WARP DISTORTION WD300
Ultimate Warp Distortion Effects Pedal
Thank you for showing your confidence in us by purchasing the BEHRINGER WARP DISTORTION WD300.
This high-quality effects pedal enables you to produce super thick, tube-like distortion plus
endless sustain. Thanks to its high-performance features you can achieve the typical hard rock
or heavy metal distortion sounds.
1. Controls
(5)
(4)
(1)
(2)
(8)
(3)
(7)
(6)
(1) The SUB switch activates a low-frequency boost at around 90 Hz to simulate the resonance
frequency of a 4 x 12" cabinet.
◊
CAUTION: The SUB filter is not suitable for all speakers and combos!
(2) The LEVEL control adjusts the output level.
(3) The WARP control adjusts the mid-frequency range. It boosts the mids from 250 Hz to 1 kHz at
minimum position. In maximum position it cuts mids at 500 Hz with a presence boost at 3 kHz.
(4) The GAIN control adjusts the input sensitivity and the amount of resulting distortion.
(5) The ON/BATT LED illuminates when the effect is activated. It also serves as a battery
level indicator.
(6) Use the footswitch to activate/deactivate the effect.
(7) Use this 1" TS IN connector to plug in the instrument cable.
(8) The 1" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery
(not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to
scratch the unit.
|