Aiphone Car Video System KB MV2 User Manual

KB-MV2, KB-MV3, KB-SWM, KB-SWS  
Color Tilt Multi-Unit Video Entrance System  
- INSTRUCTIONS -  
The KB-MV series is a color video multi-unit entry system that can be configured for buildings with two to  
twelve tenant locations. Up to three video entrance stations can be used in one system. The color camera can  
be tilted upward for a better view of the visitor, and the speaker/microphone provides hands free  
communication at the entrance panel. Inside each tenant location, the standard Aiphone KB series audio/video  
stations are employed, allowing up to five monitoring locations per tenant. If there are are less than three  
common entries, an individual audio-only or audio-video door station can be included for each tenant location.  
KB-MV2  
KB-MV3  
Microphone  
Camera Lens  
Night Vision LED  
Speaker  
Open position  
for additional  
module,  
determined by  
panel design.  
KB-SWM and KB-SWS  
with 2 GF-3P, 1 GF-2F  
Features:  
Streamline design, can be semi flush mounted or surface mounted  
Color CCD camera with tilt control  
Configure from 2 to 12 call buttons per entry, using 1-, 2-, or 3-button modular panels  
Backlit call button directory for easy viewing of names at night  
Weather resistant for outdoor use  
Hands free communication from entry panel  
Automatic night mode LED  
Employs KB series room stations  
Up to three video entry stations per tenant  
Up to five inside stations per tenant  
Selective door release from each tenant location when using RY-3DL (one per tenant)  
Easy homerun wiring from entry to each tenant using Aiphone series wire # 871802  
Page 1  
 
WIRING DIAGRAM:  
KB-MV3 + KB-SWM  
(door #1)  
KB-3MRD  
(Top button)  
1A1  
1A2  
B1  
B2  
1A1  
1A2  
2A1  
2A2  
2A1  
2A2  
PS-2420UL  
+
-
3A1  
3A2  
+
-
3A1  
3A2  
SKK-620A  
White  
+
-
Black  
KB-3MRD  
(Middle button)  
1A1  
1A2  
B1  
B2  
SKK-620A wire key:  
+ = Blk w/white stripe, Red spade lug  
- = Black wire with Green spade lug  
2A1  
2A2  
PS-2420UL  
+
-
3A1  
3A2  
+
-
KB-3MRD  
(Bottom button)  
KB-3HRD  
KB-3HRD  
1A1  
1A2  
B1  
B2  
1A1 B1  
1A2 B2  
1A1 B1  
1A2 B2  
KB-MV3 + KB-SWM  
(door #2)  
2A1  
2A2  
+
-
+
-
+
-
1A1  
1A2  
PS-2420UL  
3A1  
3A2  
+
-
+
-
PS-2420UL  
2A1  
2A2  
3A1  
3A2  
SKK-620A  
White  
+
A1  
A2  
Black  
-
KB-DAR  
(door # 3)  
Wiring Notes:  
-
-
-
-
-
Use Aiphone wire 871802, or 2-conductor, 18 AWG solid, non-shielded, PE insulated cable.  
Each entrance panel must have its own SKK-620 power supply.  
Each tenant must have its own KB-3MRD master and PS-2420UL power supply.  
Refer to KB-3MRD instructions for complete wiring, including distance limitations.  
Add RY-3DL to each tenant if releasing more than one door.  
Page 3  
 
Technical Notes:  
-
-
If a specific directory is not lit up, that KB-3MRD master is either not connected or not powered on.  
If video times out immediately or does not come on at all, it is possible that the wrong type of wire was  
used. Make sure cable is SOLID copper, non-shielded. Stranded wire cannot be used on this system.  
If the entrance panel looses 6V DC, the tenant that was last in communication with the door station, will  
be the only one to receive a call no matter what button is depressed at the entrance panel.  
-
Operation:  
-
-
-
-
-
-
Depress button at entry panel to activate chime, and video at tenant station.  
Upon receiving chime and video at tenant station lift handset to communicate to entry panel.  
To release door depress key button on tenant station.  
To tilt camera up or down, depress tilt button on tenant station.  
To view entrance panel when not called depress the monitor button.  
Entrance panel can only be viewed by one monitor at a time. If the entrance panel is occupied and another  
tenant tries to monitor the entrance panel the monitor will not come on and a brief tone will be heard.  
Specifications:  
Power Source:  
6V DC at entrance panel. Use one SKK-620 per entry panel.  
24V DC for tenant stations. Use one PS-2420UL per 2 monitors in each tenant’s location.  
14° ~ 140° F  
Operating Temperature:  
Camera Unit:  
CCD (Charged Coupled Device)  
Overall Viewing Area:  
Video Monitor:  
36" Vert. X 72" Horiz. At 20"  
4" TFT LCD  
Scanning Lines:  
525 Lines  
Call In From Door:  
4-stroke chime from door #1, 2-stroke chime from door #2, fast 8-stroke  
chime from door #3.  
Communication:  
Wire:  
Wiring Distance:  
Hands free at entry panel, handset at tenant station(s).  
18AWG solid, non-shielded, PE insulation. Use Aiphone Wire # 871802.  
650' homerun from each entrance panel to each KB-3MRD master tenant station.  
330' max. from KB-3MRD to last KB-3HRD in each tenant location.  
FCC Class B Verification  
NOTE: This equipment has been tested and found to comply with the limits for a Class B  
digital device , pursuant to Part 15 of the FCC Rules. These limits are designed to provide  
reasonable protection against harmful interference in a residential installation. This equipment  
generates, uses, and can radiate radio frequency energy and, if not installed and used in  
accordance with the instructions, may cause harmful interference to radio communications.  
However, there is no guarantee that interference will not occur in a particular installation. If  
this equipment does cause harmful interference to radio or television reception, which can be  
determined by turning the equipment off and on, the user is encouraged to try and correct the  
interference by one or more of the following measures:  
— Reorient or locate the receiving antenna.  
— Increase the separation between the equipment and receiver.  
— Connect the equipment into an outlet on a circuit different from that to  
which the receiver is connected.  
— Consult the dealer or an experienced radio/TV technician for help.  
NOTE:  
Only wiring and information relating  
to the installation of the KB-MV  
series entrance panel is contained  
here. Please consult the KB series  
Installation & Operation Manual for  
complete information on the KB  
series equipment installed in each  
tenant location.  
WARRANTY  
Aiphone warrants its products to be free from defects of material and workmanship under normal use and service  
for a period of one year after delivery to the ultimate user and will repair free of charge or replace at no charge, should  
it become defective upon which examination shall disclose to be defective and under warranty. Aiphone reserves unto  
itself the sole right to make the final decision whether there is a defect in materials and/or workmanship; and whether or  
not the product is within the warranty.  
This warranty shall not apply to any Aiphone product that has been subjected to misuse, neglect, accident, or to  
use in violation of instructions furnished, nor extended to units which have been repaired or altered outside of the  
factory. This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in  
writing by Aiphone.  
Aiphone will not be responsible for any costs incurred involving on-site service calls.  
Aiphone Communication Systems  
1700 130th Ave. N.E.  
Bellevue, WA 98005  
TOLL FREE TECHNICAL SUPPORT: (800) 692-0200  
TOLL FREE FAX LINE: (800) 832-3765  
KB-MV2 KB-MV3 Instr.  
1105PHJS  
(425) 455-0510  
FAX (425) 455-0071  
 

ADIC Server DAS V310E User Manual
Advantech Computer Hardware 2006957006 5th Edition User Manual
AKG Acoustics Drums Micing User Manual
Alliance Laundry Systems Washer Dryer HC125BYV User Manual
Aluratek Camcorder ADVC01F User Manual
AOC Flat Panel Television L22W898 User Manual
AOC TV Video Accessories I2778VHE6 User Manual
Axis Communications Intercom System A8004 VE User Manual
Bakers Pride Oven Oven XX 10 User Manual
Beko Clothes Dryer DC 7110 User Manual